Tags

, , , , , ,

On my last post, I tried to weather some southern yellow pine to make it look old. Well, this screen was the reason for my attempt. I made a couple of these screens for my wife as a backdrop for when she does shows. Building them was super simple. I took a 2 x 8 and ripped it to 3″ wide and ran a 3/4″ wide, 1/2″ deep rabbet down one side.

 photo 20150308_151936.jpg

I then pinned and glued fence boards and wood from an old pallet to the rabbets with some 18 gauge pneumatic nails to create the slats. The assembly is so simple that the majority of my time was milling the wood to the proper thickness.

 photo 20150308_151952.jpg

When making the second screen I decided to change the process just a little.

 photo blog 003_5.jpg

Instead of planing the 2 x material from 1 1/2″ down to 1″, I decided to re-saw the material to 1 1/8″ on my band saw instead. This saved a lot of time and a whole bunch of planer shavings. You can see the off-cuts that I had from building the second screen on top of my table saw. I’m sure my planer knives thank me for not having to plane off all this crap.

 photo blog 006_1.jpg

Unfortunately, a big obstacle when using 2 x material is sometimes after I rip the boards in half, they spring back due to their high moisture content. I try to buy straight grain boards with no pith in the middle, but sometimes that’s not good enough. You can see in the picture some of the boards that released their tension once I ripped them in half. I had more than a full 2 x 8 board of waste making these panels.

 photo blog 005_5.jpg

The day of the show, the screens did their trick. You can see one of them in the background, however, I think they would have looked better being toned down with a weathered stain. Maybe next time.

 photo bella.jpg

Advertisements