Big Ole Wood Shelf

Several months ago, I started making a shelving unit out of southern yellow pine that my wife asked me to make for her booth. I got this far and it sat in my shop unfinished for months. After much contemplation, my wife and I both realized that the shelving unit was really too big to fit in our Ford Edge.

20170722_120716.jpg

The best thing we could do, is take it apart and resize the thing smaller so we wouldn’t have to rent a trailer to transport it. Luckily, I put the shelf together almost entirely with pocket screws. The part that was glued, I cut apart on the band saw.

20170722_122654

After, I cut the shelves shorter, I used my router and cut floating tenons on all the pieces instead of using pocket holes screws like I did before.

20170722_131434

A few hours later, I had the new resized shelving unit put back together. The height stayed the same at five feet, but the length was cut down from five feet to forty inches so that it would fit in our car.

20170722_171943

My wife always wanted the unit to roll so I added four old casters to the bottom. We actually bought the casters many months before we decided to make the shelving unit just in case someday we needed them.

20170723_100917

With 1/2″ plywood installed for the shelves, the unit was built, but unfinished.

20170723_102601

Anita wanted the unit to look somewhat old, so I smacked the wood around with a hammer and crowbar to give it an aged look.

20170723_123747

I bought a few piece of thin gauge metal, drilled some holes in it, bent it over in my vise, painted them black, and screwed them to the corners of the shelving unit to give it a more industrial look. The brackets and the dark stain really makes the unit pop. Now it was ready to throw in the Edge and bring it to our booth. Saved us $50 not having to rent a trailer and we both feel it looks nicer then it did before.

IMG_20170812_133702_428

 

Advertisements